2-17 dialight corporation 1501 route 34 south farmingdale, nj 07727 tel: (732) 919-3119 fax: (732) 751-5778 www.dialight.co m 2 4 m m r o u n d ? o p t o p i p e t m o p t i c a l l i g h t p i p e , 4 a r r a y , p a n e l m o u n t e d 5 1 5 - 1 0 4 0 5.54 [.218] .25 [.010] 1.19 [.047] 6.35 [.250] 12.70 [.500] 19.05 [.750] ? 3.96 [.156] typ; 4 plcs 1.27 [.050] 23.11 [.91] ref .38 [.015] typ 5.54 [.218] (ribs) diffused front surface .94 [.037] typ; 3 plcs (ref) 3.25 [.128] typ (ref) 3 plcs 2.29 [.090] typ 3 plcs 10.29 [.405] 4 plcs d irection of light 4.57 [.180] major dia front panel 9.40 [.370] c.l led .51 [.020 ] max top surface of led dimensions in mm [inches] r e c o m m e n d e d m i c r o l e d s m t l e d s f o r u s e w i t h 5 1 5 - 1 0 4 0 p a r t n o . p a g e # 597-3xx1-2xx 1-21 597-3xx1-5xx 1-30 597-77x1-2xx 1-23 & 1-24 597-77x1-5xx 1-31 f e a t u r e s high transmissivity polycarbonate material ul94v-0 compliance esd protection (circuit isolation from front panel) wide viewing angle arrays reduce insertion costs secures to panel by press-fit l e d d a t a for absolute maximum ratings and other electrical and optical data on the recommended leds, refer to led data sheets. d i a l i g h t o p t o p i p e l i g h t p i p e d e s c r i p t i o n this optopipe? is mounted through the rear of the panel and is retained by press fit. the light pipe is not attached to the pcb at any point but floats above it. the diffused light emitting surfaces appear bright and uniformly illuminated. the recommended light sources are dialight's 597 series plcc-2 or plcc-4 type smt leds. the light source?s emitting surface should be located no more than 0.020" or 0.5mm from the optopipe?. the smt leds are mounted in a straight line under the rear of the part on a 6.35 mm pitch. the light pipe material is water clear transmissive polycarbonate rated ul94-v0, and has a 35% oxygen index. dialight can provide custom optopipe? solutions for your applications. o p e r a t i n g / s t o r a g e t e m p e r a t u r e ?30c to +100c recommended panel hole size: ? .175 new
|